Aluminium Air Tank 1 Gallon 3 Port (2x 3/8" 1x 1/4" )
Aluminium tank 1 Gallon, 3 port silver (approx 3 litres) H130mm x W95mm x L400mm with drain 2x 3/8" NPT Ports 1x 1/4" NPT Drain port
Control your air suspension valves with this plug and play window switch module
The AS-WSM-HOL-002 is a 9 output “plug n’ play” solution to allow for independent control of 8 airbags using the factory VY VZ master window switch. The control is switched between air suspension and windows using the factory child lock button. When the child lock button is off the window switches work as normal. Once the child lock button is pressed the output for compressor is turned on and the 8 valve outputs can be turned on using the window switches.
The front left hand window switch used to lift and lower the window will now inflate and deflate the front left airbag and so on for all other window switches.
Remove the gear surround trim by taking out the 1x Phillips head screw under the head unit pocket. Lift the gear surround from the back (near the master window switch control) and then disconnect the master window switch module. Pull the gear surround out and set aside. Remove the driver’s side front right centre console trim allowing access to tuck the AS-WSM-HOL-002 up into the cavity under the head unit and air vent. Run the plug wiring under the centre console and tuck it up under the air vents that run to the rear of the centre console. Wire in the airbag outputs including compressor killswitch as required (see below wiring info) If not using all outputs or compressor killswitch then make sure you tape the unused wiring up individually so bare wires can touch another. Plug the harness into the vehicle wiring and then refit the centre console gear surround. Plug the master window switch into the new harness and fit the gear surround back into the clips. Refit the side trim and you are all set to go.
Toggle between window switch mode and air suspension control mode using the child lock button. When in window switch mode only use 1x window switch at a time to reduce the amount of current flowing through the module. You should always only modify 1 window at a time and never continue to hold a button once the window has reached full position (up or down)
1: Front Left Airbag 2: Front Right Airbag
3: Rear Left Airbag 4: Rear Right Airbag
1 Up: Brown 2 Up: Green 3 Up: Yellow 4 Up: Blue
1 Down: Purple 2 Down: Pink 3 Down: Grey 4: Down: White
Compressor 12v + feed: Orange
1x Window swotch plug-n'-play module
1x Instruction manual (same as above information)
THIS KIT DOES NOT INCLUDE A MASTER WINDOW SWITCH. USE YOUR EXISTING WINDOW SWITCH WITH THIS MODULE
16 other products in the same category:
Aluminium tank 1 Gallon, 3 port silver (approx 3 litres) H130mm x W95mm x L400mm with drain 2x 3/8" NPT Ports 1x 1/4" NPT Drain port
Specifications: The VBVU4BK is a 4-way 8 solenoid valve block that allows for independent control of 4 airbags. It features dual 1/4” NPT inlet and exhaust ports allowing for multiple install...
Airbrake Line for Air Suspension and Onboard Air Kits Sold Per MTR DOT Approved SAE J844
Air Tank Drain Kit 1/4" Npt Remote Drain 1m Length This Drain kit allows you to drain the tank in an airbag installation from a remote area if its difficult to get to the bottom of the...
2 Corner Gauge panel with switches This gauge panel comes complete with left and right 2 way momentary switches ( up and down) as well as a digital 2 way gauge! This kit is perfect for controlling...
12v Air Compressor - Ideal for Air Suspension Specifications: Model: ASAC480B18Voltage: 12vMax Current: 23AMax Working...
Brass Straight Hex Nipple Male NPT Thread -Male NPT Thread Brass Finish
6mm Clear Acrylic Sensor arm replacement Replace your broken sensor arm with this cnc cut replacement arm Keeps the standard hole spacing and uses your existing screws to mount to sensor (Sensor...
Bolt in air suspension front strut assemblies These bags allow for full safe travel compared to some others on the market. Using triple convoluted bags means the full travel can be achieved without...
Get down low as desired with this air suspension kit for VT-VZ vehicles. This Kit comes with 95% of what you need ( missing a few installation accessories such as grommets, split tube, solder,...
If you are looking for an entry level control system that is simple while offering smartphone capabilities, the e+ Connect wireless controller is a great choice. This wireless switch box allows...
6" Double convoluted airbag Perfect for Ford BA-FG (with upper plates) and other direct bolt in airbag suspension setups. Weight: 1.9kg Diameter: 153 mm Max Load: 2500lb Load Rating @ 100psi : 635...
Specifications: The ASWK-GP3-VU2-5 is a plug and play harness to go from the GP3 series gauge panel to the VBVU2 series valve block. Simply plug in the connector to the valve block and connect the...
Aluminium air tank 5 port 3 Gallon (approx 9 litres) Tank Size is L450mm x H220mm x W180mm 2x 3/8" NPT Ports on ends 3x 1/4" NPT Ports on 1 end ( See pictures )
Specifications: The VBVU2BK is a 2-way 4 solenoid valve block that allows for independent control of 2 airbags. It features dual 1/4” NPT inlet and exhaust ports allowing for multiple install...
Interrupt Rating: 2.5KA@12VDCOperating temp: -40°C to 85°C (-40°F to 185°F)Storage temp: -40°C to 125°C (-40°F to 260°F)Terminal: #10-32 thread with quick connector.Mounting Torque Rating: 15in-lb...