Purchase items from D2I Auto & Sound
Best sellers
An electric wire ferrule (sometimes end terminal) is a metal tube crimped over stranded wire to secure the strands within a screw terminal. Electrical insulation is included to protect any exposed...
These ring terminals allow you to secure your wire to a specific point with an 8mm bolt. These are widely used in the automotive industry allowing for multiple wires to connect to a single...
These bolt in Spring locators, allow you to install springs back into your vehicle after installing bolt in airbag suspension. Kit includes: 2x Upper Plates 2x Lower plates 4x Upper bolts and...
DOT Approved Brass Swivel Elbow Male NPT Thread - Push to Connect Tube ( Outside Diameter) DOT Approved O Rig Seals Brass Finish (1/8" NPT- 5/32" ( 4mm) are Nickle finish)
Active filters
Specifications: The VBVU4BK is a 4-way 8 solenoid valve block that allows for independent control of 4 airbags. It features dual 1/4” NPT inlet and exhaust ports allowing for multiple install...
Specifications: The VBVU2BK is a 2-way 4 solenoid valve block that allows for independent control of 2 airbags. It features dual 1/4” NPT inlet and exhaust ports allowing for multiple install...
Air Tank Drain Kit 1/4" Npt Remote Drain 1m Length This Drain kit allows you to drain the tank in an airbag installation from a remote area if its difficult to get to the bottom of the...
Height Sensor Suits Accuair New Plug The AArot120 Height sensors are direct replacements for the Accuair Elevel height sensors as well as other autolevel sensors that use the AA-ROT-120...
Finish: Black and Chrome style finish with RED LED display Dimensions: 52mm Mounting Diam Sender units: 1/8" NPT Thread Working Range: Approximately 0-220PSI
Pressure switches are used to automatically turn a compressor on when the pressure is getting low and off when it reaches its desired level. This is a fixed (non adjustable) pressure switch which...
4 Corner Height Sensor Harness Direct replacement for Accuair, Levelride and other autolevel system sensor harnesses. Labelled Sensor plugs 1- Front Left 2- Front Right 3- Rear Left 4- Rear Right...
DOT Approved Brass Swivel Elbow Male NPT Thread - Push to Connect Tube ( Outside Diameter) DOT Approved O Rig Seals Brass Finish (1/8" NPT- 5/32" ( 4mm) are Nickle finish)
DOT Approved Brass Straight PTC Male NPT Thread - Push to Connect Tube ( Outside Diameter) DOT Approved O Rig Seals Brass Finish (1/8" NPT- 5/32" ( 4mm) are Nickle finish)
Brass Socket Plug Male NPT Thread Brass Finish Allan Key Drive
Brass Straight Hex Nipple Male NPT Thread -Male NPT Thread Brass Finish
7" Double convoluted airbag Perfect for Holden VT-VZ other direct bolt in airbag suspension setups. Weight: 2.5kg Diameter: 180mm Max Load: 2600lb Load Rating @ 100psi : 970.7kg Stud Size: 3/8"...
